监控方法如下~
IBM-AIX:
$ lsdev -Cc adapter|grep ent
ent0 可用 10-80 IBM 10/100 Mbps Ethernet PCI Adapter (23100020)
$ netstat -v ent0
-------------------------------------------------------------
ETHERNET STATISTICS (ent0) :
Device Type: IBM 10/100 Mbps Ethernet PCI Adapter (23100020)
Hardware Address: 00:06:29:04:75:9a
经过时间:89天0小时53分48秒
发送统计数字: 接收统计数字:
-------------------- -------------------
数据包:3526660 数据包:16261940
字节:330655945 字节:4278385424
中断:3641 中断:15786259
发送错误号:0 接收错误号:0
已卸下的数据包:1 已卸下的数据包:0
错误的数据包:0
“S/W 发送队列”上的最大数据包:28
S/W 发送队列溢出:0
当前的 S/W+H/W 发送队列长度:1
Broadcast Packets: 4360 Broadcast Packets: 11310319
Multicast Packets: 2 Multicast Packets: 61539
No Carrier Sense: 0 CRC Errors: 0
DMA Underrun: 0 DMA Overrun: 0
Lost CTS Errors: 0 Alignment Errors: 0
Max Collision Errors: 0 No Resource Errors: 0
Late Collision Errors: 0 Receive Collision Errors: 0
Deferred: 0 Packet Too Short Errors: 0
SQE Test: 0 Packet Too Long Errors: 0
Timeout Errors: 0 Packets Discarded by Adapter: 0
Single Collision Count: 0 Receiver Start Count: 0
Multiple Collision Count: 0
Current HW Transmit Queue Length: 1
General Statistics:
-------------------
No mbuf Errors: 0
Adapter Reset Count: 0
Adapter Data Rate: 200
Driver Flags: Up Broadcast Running
Simplex AlternateAddress 64BitSupport
PrivateSegment DataRateSet
IBM 10/100 Mbps Ethernet PCI Adapter (23100020) Specific Statistics:
------------------------------------------------
Chip Version: 26
RJ45 Port Link Status : up
Media Speed Selected: Auto negotiation
Media Speed Running: 100 Mbps Full Duplex
Receive Pool Buffer Size: 384
No Receive Pool Buffer Errors: 0
Inter Packet Gap: 96
Adapter Restarts due to IOCTL commands: 1
Packets with Transmit collisions:
1 collisions: 0 6 collisions: 0 11 collisions: 0
2 collisions: 0 7 collisions: 0 12 collisions: 0
3 collisions: 0 8 collisions: 0 13 collisions: 0
4 collisions: 0 9 collisions: 0 14 collisions: 0
5 collisions: 0 10 collisions: 0 15 collisions: 0
Excessive Deferrals: 0
HP-UX:设备的文件系统其实蛮不错的,就是使用复杂啊~
# lanadmin
Message catalog can't be opened/accessed for language zh_CN.hp15CN.
Language C will used.
LOCAL AREA NETWORK ONLINE ADMINISTRATION, Version 1.0
Thu, May 20,2010 10:07:08
Copyright 1994 Hewlett Packard Company.
All rights are reserved.
Test Selection mode.
lan = LAN Interface Administration
menu = Display this menu
quit = Terminate the Administration
terse = Do not display command menu
verbose = Display command menu
Enter command: lan
LAN Interface test mode. LAN Interface PPA Number = 0
clear = Clear statistics registers
display = Display LAN Interface status and statistics registers
end = End LAN Interface Administration, return to Test Selection
menu = Display this menu
ppa = PPA Number of the LAN Interface
quit = Terminate the Administration, return to shell
reset = Reset LAN Interface to execute its selftest
specific = Go to Driver specific menu
Enter command: display
LAN INTERFACE STATUS DISPLAY
Thu, May 20,2010 10:07:17
PPA Number = 0
Description = lan0 HP PCI-X 1000Base-T Release B.11.31.0809
Type (value) = ethernet-csmacd(6)
MTU Size = 1500
Speed = 100000000
Station Address = 0x2264936eb5
Administration Status (value) = up(1)
Operation Status (value) = up(1)
Last Change = 257
Inbound Octets = 3657537035
Inbound Unicast Packets = 59966166
Inbound Non-Unicast Packets = 11596129
Inbound Discards = 0
Inbound Errors = 0
Inbound Unknown Protocols = 2381339
Outbound Octets = 1094969340
Outbound Unicast Packets = 65747327
Outbound Non-Unicast Packets = 14085
Outbound Discards = 0
Outbound Errors = 0
Outbound Queue Length = 0
Specific = 655367
Press <Return> to continue
Ethernet-like Statistics Group
Index = 1
Alignment Errors = 0
FCS Errors = 0
Single Collision Frames = 0
Multiple Collision Frames = 0
Deferred Transmissions = 0
Late Collisions = 0
Excessive Collisions = 0
Internal MAC Transmit Errors = 0
Carrier Sense Errors = 0
Frames Too Long = 0
Internal MAC Receive Errors = 0